Dell optiplex 3020 upgrade graphics card
- #Dell optiplex 3020 upgrade graphics card install
- #Dell optiplex 3020 upgrade graphics card drivers
- #Dell optiplex 3020 upgrade graphics card windows 10
The Optiplex 7010 uses DDR3 PC3-12800 which is quite expensive and depending on how much you already have, might not be a worthwhile upgrade.
#Dell optiplex 3020 upgrade graphics card windows 10
In my opinion, 8Gb is the minimum to run Windows 10 smoothly. In my opinion, 4Gb is the minimum to run Windows 10 smoothly.Īdditional RAM can make a massive difference to performance, but the performance increase does depend on what applications you typically use. It’s much faster, but cost is about the same.Īdditional RAM will only make a significant difference if the applications that you typically run demand more RAM than you have.NVMe drives are less CPU Intensive than SATA drives.If you choose the SSD carefully, you can get one for very little money.You may be wondering if it is worth putting an NVMe drive in a machine this old, but I think it is for three reasons: Then it will boot without any error messages. Press F2 to go into the BIOS settings, go into System Configuration and then Drives and then untick SATA-0. Note, If you remove the hard drive completely you will get an error on boot which says: Alert! Hard Drive not found.
#Dell optiplex 3020 upgrade graphics card install
If your current disk uses MBR you will need to do a fresh install of Windows on to the NVMe drive.Īfter I finished the NVMe upgrade, I removed the hard drive and SATA cable to make the airflow a bit better: You can clone your existing hard drive to the NVMe drive, but only if it is formatted with the GPT partition scheme. Then all you need to do is make sure your machine is set to UEFI boot, and select the USB flash drive as the primary boot device. I also modified the ist to reduce the boot delay, you can copy my config from here. I deleted everything else from the EFICLOVERdriversUEFI folder, so it only contained NvmExpressDxe.efi.
#Dell optiplex 3020 upgrade graphics card drivers
Select your USB Stick and click format:.Insert the USB Stick that you are going to boot from into the machine.The next step is to make the flash drive bootable: These Sandisk Ultra Fit drives are really neat, it barely protrudes from the machine. I put the USB Flash drive in the back of the machine: Here is the drive installed into the adapter:īy using Clover Bootloader, the USB Flash Drive will enable the machine to boot from the NVMe drive. This tiny Sandisk Ultra Fit USB Flash Drive.Western Digital Blue 500Gb NVMe M.2 PCIe Drive.Here is the equipment I used, all from Amazon: The Optiplex 7010 does not have an NVMe slot.Upgrade to a PCIe NVMe Solid State DriveĪn NVMe Solid State Drive provides the very best performance, but the procedure is slightly more complicated for two reasons: You can use the same procedure as above to clone the drive.