Volvo vida dice how to user guide
#Volvo vida dice how to user guide series
This runs through a series of application and releases of the parking brake to make sure it all works. Once both sides have been replaced and bolted up you go back to the EST201 and scroll up to Installation Check. The new bolts are supplied with the pads and come pre-coated with some thread locking agent: Then position the piston carrier back in place and bolt it on using the new bolts. I thought at first it would be one of those you have to rotate but in fact it simply pushes (I used a bit of timber batten and a tyre lever) The next step is to push the piston back in. The offside had about 2mm left, the near side had about 3.5mm. This is the worst of the old pads after 60k miles of use. Here is a comparison of old and new pads. Put the new pads into the clips in the reverse of taking the old ones out: The old pads are held in place by the clips so don’t fall out, simply wiggle them a bit and they come free of the clips: Once removed the piston and carrier can swing clear to expose the pads. This needs a 13mm spanner and also a 15mm open ender to hold the inner part still. Undo the bolts that hold the piston carrier. Selecting advanced brings up the service menu:įrom here you can have fun activating and deactivating the parking brake without using the normal switch but to carry in with the job select “Activate Service” When you select this you will hear the parking brake unwinding, just like when you normally release it but for longer.
The next step is to scroll down to advanced:
#Volvo vida dice how to user guide software
If you want to you can check for any stored codes etc and you can also read the car’s software versions. You then select Volvo from the list of manufacturers (item 4): Plug the EST201 into the diagnostic socket (located just below the handbrake switch) and turn on the ignition (no pedals so you don’t start the engine) Start by chocking the front wheels and jacking up the rear and making sure the car is properly supported. – Brake Pads for cars with Solid Rear Discs: Part Number 30794555 Tutorial I used an Autel MaxiEST EST201 with V1.08 software for the release and reactivation of the Electric Parking Brake. This is based on solely my own experience having just done it but I take no responsibility for the contents! Here is a simple guide to replacing the rear pads on my >07 Volvo with electric parking brake.